Edimax EW-7416APN V2 Manual de usuario descargar pdf (Pagina 60)

IV. APPENDIX

IV-1. Configuring your IP address

Before you use this access point, you may need to modify the IP address of

your PC or Macintosh. The procedure for doing so varies across different

operating systems; please follow the appropriate guide:

- IV-1-1. Windows XP

- IV-1-2. Windows Vista

- IV-1-3. Windows 7

- IV-1-4. Windows 8

- IV-1-5. Mac OS

This is since the access point’s default IP address 192.168.2.1 may not be in

the same IP address subnet of your network; meaning you are unable to

access the browser based configuration interface. In order to access the

browser based configuration interface, your computer’s IP must be

192.168.2.x where x is a number in the range 1-254, meaning the access

point’s default IP address is in the same IP address subnet of your network. So

if it isn’t already, then you need to modify the IP address of your computer to

192.168.2.10.

After you access the browser based configuration interface, you can change

the IP address of the access point as shown in III-8-2. Management IP, to one

that is within the same IP address subnet of your network; meaning you will

not have to modify the IP address of your computer again in future when you

wish to access the browser based configuration interface.

Note: Please ensure that your access point is

switched on and connected to your computer

via Ethernet cable before you begin.

IV-1-1. Windows XP

1. Click the “Start” button, located in the lower-left corner of your computer,

and then click “Control Panel”. Double-click the “Network and Internet

Connections” icon, followed by “Network Connections” and then

double-click “Local Area Connection”.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 88 89

Sin comentarios

Edimax EW-7416APN V2 Manual de usuario Pagina 60