Edimax N300 Manual de usuario descargar pdf (Pagina 50)

Passphrase Key

Shows the WPA passphrase here, though all

characters will be replaced by asterisks for

security reasons. If encryption is not set on

this access point, this field will be blank.

Device

Configuration

Configuration options for the device’s WPS

settings can be found here.

Config Mode

There are “Registrar” and “Enrollee” modes

for the WPS connection. When “Registrar”

is enabled, the wireless clients will follow

the access point’s wireless settings for WPS

connections. When “Enrollee” mode is

enabled, the access point will follow the

wireless settings of wireless client for WPS

connections.

Configure via

Push Button

Click “Start PBC” to start Push-Button style

WPS setup. This access point will wait for

WPS requests from wireless clients for 2

minutes. The “WLAN” LED on the access

point will stay on for 2 minutes while this

access point waits for incoming WPS

requests.

Input Client PIN

Code

Please input the PIN code of the wireless

client you wish to connect, and click the

“Start PIN” button. The “WLAN” LED on the

access point will stay on while this access

point waits for incoming WPS requests.

Note: When using PBC-type WPS setup, you must

press the hardware or software WPS button on the

wireless client within 120 seconds. If you do not do

so in time, you will need to activate WPS on this

access point again.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 91 92

Sin comentarios

Edimax N300 Manual de usuario Pagina 50