
30
2-4-5 AP Bridge-WDS Mode
In this mode, this wireless access point will connect to up to four wireless access points
which uses the same mode, and all wired Ethernet clients of every wireless access points will
be connected together. You can use this mode to connect a network to other networks which
is physically isolated.
When you use this mode, this access point is still able to accept wireless clients.
When you select ‘AP Bridge-WDS’, the following options will be displayed:
Here are descriptions of every setup item:
Band Please select the wireless band you wish to use. By
selecting different band setting, you’ll be able to
allow or deny the wireless client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz
(G), only wireless clients using the wireless band
you select (802.11b, 802.11 Draft-N, or 802.11g)
will be able to connect to this access point.
Comentarios a estos manuales