Edimax CV-7428nS Manual de usuario descargar pdf (Pagina 23)

Passphrase Key

Shows the WPA passphrase here, though all

characters will be replaced by asterisks for

security reasons. If encryption is not set on

the wireless bridge, this field will be blank.

Device

Configuration

Configuration options for the device’s WPS

settings can be found here.

(Client Device)

Config Mode

“Enrollee” mode is for the WPS connection.

When “Enrollee” mode is enabled, the

wireless bridge will follow the wireless

settings of wireless router/access point for

WPS connections.

Configure via

Push Button

Click “Start PBC” to start Push-Button style

WPS setup. The wireless bridge will wait for

WPS requests from wireless clients for 2

minutes. The “WLAN” LED on the wireless

bridge will stay on for 2 minutes while the

wireless bridge waits for incoming WPS

requests.

Send PIN Code

to AP/Router

You can use this WPS PIN code number then

key into firmware WPS page of your wireless

router(or Access Point).

Note: When using PBC-type WPS setup, you must

press the hardware or software WPS button on the

wireless router/access point within 120 seconds. If

you do not do so in time, you will need to activate

WPS on the wireless bridge again.

III-4. Wireless Advanced

In “Wireless Advanced” you can configure the advanced

features of the wireless bridge. Please do not modify

these settings unless you are sure what effect the changes

will have on your wireless bridge; advanced settings are

for experienced users only.

Note: Changing these settings can adversely

affect the performance of your access point.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 66 67

Comentarios a estos manuales

Sin comentarios

Edimax CV-7428nS Manual de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan Edimax CV-7428nS