880022..1111bb//gg WWLLAANN UUSSBB AAddaapptteerr wwiitthh WWii--FFii DDeetteeccttoorr User’s Manual Version: 1.1 (M
4 How to use the Wi-Fi Detector 1. Slide the power switch to the “ON” position, and a welcome screen will greet the user. 2. After the welcom
The Icons on the LCM display are displayed as follows: 1. Operating Channel: Indicates the current operating channel of the detected Wi-Fi signal.
5 How to install the driver and utility Before you proceed with the installation, please notice following descriptions. Note1: Please do not instal
B. If you want to install the software program in another location, click “Browse” and select an alternative destination. Then, click “Next”. C.
II. Install the USB adapter A. Plug the USB adapter into the USB port of your computer. B. The “Found New Hardware Wizard” is displayed, select “Inst
D. Click “Finish” to complete the installation. III. Using the Configuration Utility To setup the USB adapter, double-click the icon in the system
First Way A. Double-click the utility icon in the system tray. B. Click “Yes” to use the utility of the USB adapter. 11 Second Way
6 How to configure the utility The Configuration Utility is a powerful application that helps you configure the 802.11g Wireless LAN USB adapter and
Parameter Description Mode Station – Set the USB adapter a wireless client. Access Point – Turns the USB adapter to function as a wireless AP. Ple
Parameter Description Signal Strength This bar shows the signal strength level. The higher percentage shown in the bar, the more radio signal been r
COPYRIGHT Copyright © 2004/2005 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, s
Parameter Description Tx Rate There are several options including Auto/1/2/5.5/11/6/9/12/18/24/36/48/54Mbps for you to select. When the “A
Parameter Description Authentication Mode This setting has to be consistent with the wireless networks that the adapter intends to connect. Open Sys
6.3 WEP and WPA Encryption WEP is an data encryption algorithm, which protects Wireless LAN data in the network against eavesdropping. WEP has been
Parameter Description Key1 ~ Key4 The keys are used to encrypt data transmitted in the wireless network. Fill the text box by following the rules be
Parameter Description Connect Information It is the setting for WPA mode. Protocol This adapter supports two kind of protocol for authen
Parameter Description WEP Key If the AP uses WEP data encryption function, please clcik “WEP KEY SETTING“ to setup the WEP key. WEP KEY S
Parameter Description Power Consumption Setting Continuous Access Mode (CAM) – The adapter will always set in active mode. Maximum Power-Saving Mod
Parameter Description Mode Station – Set the USB adapter a wireless client. Access Point – Turns the USB adapter to function as a wireless AP. Ne
6.5.2 AP General Connection Setting Click “More Setting”, users are allowed to setup the AP connection setting, Encryption Setting and other advance
Parameter Description Tx Rate There are several options including Auto/1/2/5.5/11/6/9/12/18/24/36/48/54Mbps for you to select. When the “A
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital dev
Parameter Description Fragement The value defines the maximum size of packets, any packet size larger than the value will be fragmented. If you have
Parameter Description Filter Type Disable – Disable the MAC Address filter function. Accept – Only the wireless adapters with the MAC Address setup
7 Troubleshooting This chapter provides solutions to problems usually encountered during the installation and operation of the adapter. 1. What i
5. What is Infrastructure? An integrated wireless and wireless and wired LAN is called an Infrastructure configuration. Infrastructure is applicab
12. What is DSSS?What is FHSS? And what are their differences? Frequency-hopping spread-spectrum (FHSS) uses a narrowband carrier that changes freq
R&TTE Compliance Statement This equipment complies with all the requirements of DIRECTIVE 1999/5/CE OF THE EUROPEAN PARLIAMENT AND THE COUNCIL o
CONTENTS 1 Introduction ...1 1.1 Features...
1 Introduction Thank you for purchasing this 802.11b/g WLAN USB adapter with Wi-Fi Detector. This convenient device instantly detects wireless hotsp
• Data Rate: 54/48/36/24/18/12/11/9/6/5.5/2/1Mbps auto fallback • Security: 64/128/256-bit WEP Data Encryption, WPA (TKIP with IEEE 802.1x) and WPA
2 The Outward Appearance of the Wi-Fi Detector 3
3 How to charge the Wi-Fi Detector 1. Remove the cap from the Wi-Fi Detector, slide the power switch to the “ON” position and carefully insert the
Comentarios a estos manuales